Supervisor 3500 Installation Instructions
PUD3673R1-1
For assistance: support@alvaradomfg.com +1 (909) 591-8431
Page 25
The SU3500 offers the following user-configurable operational modes. Refer to the SU3500 User Guide for more information on
SU3500 operating modes and configuration instructions.
There is a power key switch on the end cabinet of all master and center
cabinets.
1. Turn on AC power using the power key switch [Figure 24]. The
power-up cycle will take less than one minute to complete.
2. After the power-up sequence has completed, the SU3500 barrier
wings will move to the Home position and the SU3500 will enter into
Controlled Passage mode [Figure 24], for both the entry and exit
directions.
Fig. 24
Barrier wings are pre-aligned at the factory. However, they may need
slight adjustment after installation. Refer to Appendix A on Page 29
for instructions on setting the barrier wing Home/Closed Position.
The keys to power the turnstile ON/OFF are packaged in the hardware
box that was shipped with the turnstile.
Powering On
Power Key Switch
Operating Modes
NOTE
NOTE
OFF
ON
The barrier wings are closed, securing the turnstile. Upon receipt of an authorization signal from an access control system the
barrier wings open, allowing a single passage in the authorized direction. The barrier wings return to the closed position after the
user has passed through the turnstile or the time frame allowed for an entry to occur has expired.
The barrier wings are open, providing a barrier-free passageway. The barrier wings will not close and secure the turnstile unless an
unauthorized passage is attempted. Normally Open mode should be used only in select applications.
The barrier wings remain open at all times allowing the SU3500 to function as an optical (barrier free) access control turnstile.
Normally Closed
Normally Open
Barrier Disabled
