This device is intended only for OEM integrators under the following conditions:
1)
Due to the facts that this module has high built-in output power and with a
high gain direction antenna, the module can be used in a professional
installed end product only. The final product must be professional installed
to make sure that 165 cm can be maintained between the antenna and users,
and
2)
The transmitter module may not be co-located with any other transmitter
or antenna.
As long as 2 conditions above are met, further transmitter test will not be
required. However, the OEM integrator is still responsible for testing their
end-product for any additional compliance requirements required with this
module installed
IMPORTANT NOTE: In the event that these conditions can not be met (for
example certain laptop configurations or co-location with another transmitter),
then the FCC authorization is no longer considered valid and the FCC ID can
not be used on the final product. In these circumstances, the OEM integrator
will be responsible for re-evaluating the end product (including the transmitter)
and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna
may be installed such that
165 cm
may be maintained between the antenna and
users. The final end product must be labeled in a visible area with the following:
“Contains FCC ID:
LKT-BULTRA-5
”. The grantee's FCC ID can be used only
when all FCC compliance requirements are met.
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the user’s manual of the
end product which integrates this module.
The end user manual shall include all required regulatory information/warning as
show in this manual.
