background image

©2015

 Alvin & CompAny, inC.

4

©2015

 Alvin & CompAny, inC.

  •  P.O. Box 188, Windsor, CT 06095-0722

Phone: 860-243-8991  •  Toll-Free: 800-444-2584  •  Fax: 860-242-8037  •  Toll-Free Fax: 800-777-2896

www.alvinco.com 

LIT-A15019  10/15

#SH15 – Straightedge Hardware Kit for Model Series 1101 and 2201 made after 2015
Contains:

2 Front Wire Connectors
2 Rear Wire Connectors
2 Rear Pulleys
2 Washers
1 Clinch Stud
1 Rear Adjustment Knob
(6) 3/4" Screws

Wire not included and must  

be ordered separately (item PEP-2).

#PEP-2 – Straightedge Rewiring Kit for  

Model Series 1101 and 2201
Contains:

1 Spring
2 Eyelets
2 Front Wire  

Connectors
27½' of Wire  

(for straightedges  

30" to 60" in length)

#SEK15 – Replacement Straightedge  

End Caps for Models 1101 and 2201  

made after 2015 

Contains:

2 End Caps
2 T-Shaped Screws
2 Brake Knobs

Replacement Parts

1101-42 in use with 
Alvin

®

 ONX40-4 

drafting table

4

Summary of Contents for 1101 Series

Page 1: ...raightedges will not work properly on warped boards Position front and rear wire connectors C D E on top of drawing board as shown in Figure 1 Use chart below to determine proper spacing Center the straightedge B on the board Mark screw positions for front and rear wire connectors and pre drill pilot holes about 1 4 deep using a 1 16 drill bit Use care not to drill through the board TIP Wrap maski...

Page 2: ...sing through lower left connector and wrap wire around mounting screw Fasten screw securely Repeat on the right side using care to set spring tension as directed in Figure 5 for best performance Excess wire can be trimmed off but leave several inches for future adjustment 1 2 3 4 5 To Adjust Lock Parallel Straightedge Position Be sure both brake knobs B and rear adjustment knob G are free and loos...

Page 3: ...crew as shown in wiring Figure 9 and pass it around rear pulley F in upper left corner of board Connect to spring at top A Grasp the wire on right side not connected to spring from left side Trial and error method will be required here Pass this wire around straightedge blade pulley and brake screw then pass it around pulley in upper right corner of board Connect to spring at top Pass lower left a...

Page 4: ...ar Wire Connectors 2 Rear Pulleys 2 Washers 1 Clinch Stud 1 Rear Adjustment Knob 6 3 4 Screws Wire not included and must be ordered separately item PEP 2 PEP 2 Straightedge Rewiring Kit for Model Series 1101 and 2201 Contains 1 Spring 2 Eyelets 2 Front Wire Connectors 27 of Wire for straightedges 30 to 60 in length SEK15 Replacement Straightedge End Caps for Models 1101 and 2201 made after 2015 Co...

Reviews: