Olympian Chair
(Drafting Height)
Assembly Instructions
For model
CH300-40DH
Parts Included:
Tools Required:
Allen wrench
Important:
Keep screws loosely tightened during the assembly process.
Tighten them fully once chair is assembled or when instructed.
5
Place the back rest (
G
) face up on a clean, flat surface with
the attached brackets facing up. See
Figure 2
.
6
Position the seat (
H
) so that the holes are lined up with the
holes on the back rest brackets.
7
Use three metal bracket screws (
I
) in the middle 3-hole
metal bracket to attach the seat and the back rest. Leave
screws loosely tightened until all screws are in place.
8
Use four seat and back rest bracket screws (
J
) in the outer
back rest brackets to firmly attach the seat to the back rest.
Tighten all screws.
E
1pc Seat Post
F
1pc Seat Post Cover
H
1pc Seat
K
1pc Mechanism
I
3pcs Metal Bracket Screws
J
4pcs Seat and Back
Rest Bracket Screws
L
4pcs Mechanism Screws
N
2pcs Arm Width Adjustment
Knob and Washers
A
5pcs Casters
H
J
G
J
I
To Assemble:
Unpack and inspect contents to
confirm you have all pieces pictured.
1
Attach five casters (
A
) to the legs of the
wheel base (
B
) as shown in
Figure 1
.
2
Insert the extender (
C
) into the wheel
base, followed by the foot ring (
D
)
inserted into the extender.
Insert the seat post (
E
) into the foot ring
and cover with the seat post cover (
F
),
with narrowest part at the top.
3
4
B
1pc Wheel Base
G
1pc Back Rest
Figure 1
Figure 2
M
2pcs Armrest
D
1pc Foot Ring
C
1pc Extender
C
B
A
D
E
F
Page 1 of 2
