Ensign Table
Tools Required:
Phillips screwdriver, drill with
1
/
16
" bit, measuring tape, pencil (not included)
Assembly Instructions
Parts Included:
Warning: Do not cut restraining cord until after reading instructions
This table is spring-loaded and might cause bodily harm if assembled incorrectly. Remove
contents carefully from carton but do not cut table restraining cord until reading the assembly
instructions fully and taking necessary precautions as described below.
With the carton in the upright position, remove the table
frame (
A
) and feet/hardware box as shown in
Figure 1
. Do
not cut restraining cord yet and do not release brake lever yet.
1
2
A
1pc Table
Frame
C
4pcs
Foot Bolts
D
4pcs
Washers
E
4pcs
Tabletop Screws
F
1pc
Wrench
G
1pc Allen Wrench 5mm
1pc Allen Wrench 10mm
Table Assembly
Figure 1
Figure 2
x2
B
C
x4
x4
D
A
1
©2012 Alvin & CompAny, inC.
Attach feet (
B
) using foot bolts (
C
) and washers (
D
)
provided. Be sure that the long ends of feet extend
toward the front of the table, as shown in
Figure 2
.
Tighten bolts very securely.
Front of
table
Long ends of
feet on front
side of table
Do not cut
restraining
cord yet
Do not
release
brake
lever yet
B
2pcs
Feet
H
Spring
Tension Bolt
