MiniMaster
™
Drawing Table
Tools required:
Phillips screwdriver.
Assembly Instructions
Parts Included:
A
2pcs Leg Frame
B
1pc Table Top
F
2pcs
Front
Extension
Tubes
To Assemble:
Unpack and inspect contents to confirm that you have all parts
listed above.
Screw floor glides (
G
) or casters (
H
), whichever you prefer, into
bottom tubes of left and right leg frames (
A
).
Place back panel (
C
) on a bench or table (at least 20" high) with
ends hanging over the edge and threaded holes facing up.
Hang left leg frame (
A
) on top of back panel (
C
) as shown in
Figure 1
. Align holes in steel flange with holes in back panel and
install ½" Allen bolts (
K
). Be sure ends of back panel are pushed
flush against steel tubing and tighten bolts securely.
Repeat step
4
for right leg frame (
A
).
Carefully remove base assembly from table/bench and place
upright on floor. Use care not to overstress back panel connections
at this time.
Place shelf (
D
) with pre-drilled holes facing down onto the steel
shelf flanges. Attach with ½" Allen bolts (
K
) from below. Be sure
ends of shelf panel are pushed flush against steel tubing and
tighten bolts securely.
Insert front and rear extension tubes (
E
and
F
) into base assembly.
Pay close attention to correct orientation of attachment brackets
on left and right rear tubes, as shown in
Figure 2
. Install height
adjustment knobs (
J
) in each leg and set each extension tube in
the third hole for the time being.
Extension tube holes align with height adjustment knobs when
half of the hole above is showing, as shown in
Figure 3
. Set base
assembly aside.
1
2
3
4
Colored surface both sides
C
1pc Back Panel
Colored surface one side only
D
1pc Shelf
Left
Right
Left
Right
E
2pcs Rear
Extension
Tubes
G
4pcs
Floor Glides
H
4pcs
Casters
M
1pc Pencil Ledge
J
4pcs
Height
Adjustment
Knobs
K
8pcs
½" Allen
Bolts
L
10pcs
5
⁄
8
" Wood
Screws
5
6
7
8
Hint
Adjustment
Knob
Front
Extension
Tube
Rear Extension Tube
½" Allen
Bolt
Figure 2
Floor Glides
½" Allen
Bolts
Figure 1
For MM36-3-WBR and
MM36-5 purchased after April 2008
