Professional Table
Tools Required:
Phillips screwdriver, ruler, and drill with 1/16" bit (tools not included)
Assembly Instructions
Figure 3
MODEL X-3-XB, MODEL X-4-XB,
MODEL XI-3-XB, MODEL XI-4-XB,
MODEL XII-3-XB, MODEL XII-4-XB
Parts Included:
A
1pc Leg Frame
Unfold leg frame (
A
). Insert rear extension tubes (
C
) into
back tubes of leg frame with mounting brackets facing out.
Slide tubes in as far as they will go and then loosely hand-
tighten height adjustment knobs (
F
). See
Figure 1
.
Insert front extension tubes (
D
) into front tubes of leg
frame with the curved black caps facing front and back. See
Figures 1 & 2
. Set each tube at a height of approximately 4"
and then loosely hand-tighten height adjustment knobs.
Place tabletop (
B
) with preferred side down on a
carpeted or protected floor to prevent scratching. Turn the
assembled base frame upside down and place on tabletop
with front guide tracks (
G
) placed (but not screwed in yet)
under the front extension tubes. See
Figure 3
.
1
2
B
1pc Tabletop
C
2pcs Rear Extension Tubes
E
2pcs Floor Glides
(Already installed
into legs)
F
4pcs Height
Adjustment Knobs
H
12pcs 1/2"
Wood Screws
To Assemble:
Unpack parts and inspect to confirm that all are present.
G
2pcs Front Guide Tracks
3
D
2pcs Front Extension Tubes
(Shipped in
separate box)
Figure 2
B
C
C
C
F
G
G
D
D
D
Page 1 of 2
Assembled table
Figure 1
