9. Power On Steps
Before Power On the Gimbal:
1. Please check the polarity on IMU cable making sure the vcc and gnd are connected to correct pins.
2. Make sure the IMU is facing down/ Upward for the new version when installing. Refer to IMU
Mounting section.
3. We suggest to use 3s battery for GoPro or similar size cameras.
4. Double check the battery polarity before plugged in.
5. The Brushless Gimbal Controller is preset to plug-n-play with GoPro camera. There is no
additional tuning needed.
Follow the following sequencies to power on your Senrigan-GP-45 Brushless Gimbal correctly.
Step 1.
Prepare a 2-3S 800mAh (recommended to use with 3S 11.1V) Lipo Battery which must has JST connector, or
you can get the supply voltage from your 3S Lipo flying battery using a JST to 3S Balance Connector(not
included).
Step 2.
Place the Senrigan-GP-45 Gimbal Assembly on the ground and keep it steady during the starting process.
Step 3.
Connect the Battery to the Power Cable of the Gimbal (JST connector) and wait for around 15 seconds. IMU is
now initialing.
(Do not move the Gimbal during the initialisation process, otherwise the Gimbal will fail to
start!)
After the Initialization Process, the Tilt and Roll Motors will move slowly to the center position. The
camera will now be stayed in the level position.
If the Gimbal fail to start normally, reboot the power and try again.
(Remember never move the Gimbal during
the Initialization Process.)
Step 4.
Ready to go.
Page 16 of 16
