M1701_POS_Pro_Manual V1.0 2012-06-12
6
4.7.
Green Function
If the connected loads are drawing less than 20 watts, the UPS will
automatically shutdown after 5 minutes in back-up mode in order to
conserve battery power.
To disable “GREEN FUNCTION” press and hold the “On” button during
initial start-up for at least 3 seconds, until a beep-beep sound is heard.
AUDIBLE ALARM
4.8.
Back-Up (Slow Alarm)
When in back-up mode, the LED flashes every 2 seconds and the UPS
sounds an audible alarm. The alarm stops when the UPS returns to line
normal operation. Press the On/Off/Test/Silence Button during back-up
mode to silence the beeping.
4.9.
Low Battery (Rapid Alarm)
In back-up mode, when the battery energy runs low, the UPS beeps
rapidly until the UPS shuts down from battery exhaustion or returns to line
normal operation.
4.10.
Overload (Continuous Alarm)
When the UPS is overloaded (the connected load exceeds the maximum
rated capacity of the UPS) the UPS sounds a continuous alarm to warn of
an overload condition. Disconnect non-essential loads until the UPS stops
the alarm.
4.11.
Replace Battery (Continuous Alarm)
The UPS emits a continuous beep if the battery fails the self-test. See
replace battery section for battery replacement or call your dealer for
services.
