19
Simple Fault Removal Guidance
Trouble
Key points of inspection
1. The car cannot
be started
1) (Option A, B) Check if the battery is fully charged. You can
observe the display of the central control panel to check whether
the voltage is above 12 V.
(Option C, D) Check if the battery is fully charged. You can
observe the display panel of the central control panel to check
the voltage is above 6 V.
2) Check the power switch, all plugs of the dash receiver under
the seat, and the battery terminal line are properly inserted.
3) Check whether the circuit of the over-current protector is
automatically disconnected (when the car is overloaded and
blocked, the circuit of the over-current protector will be
disconnected to protect the motor and dash receiver)
4) Check whether the car has been stored for a long time and its
battery is not charged on time.
5) If the remote control cannot start the car, please check
whether the remote-control code-matching function is normally
operated.
6) Check whether the remote-control battery power is low.
2. Music sound is
distorted or silent
Check whether the battery power is enough, and charge or
replace the battery if not.
Operation of overcurrent protector
•
The overcurrent protector is installed under the seat. You can see it by twisting
the seat screw off (as shown in the figure) and taking the seat away.
•
When the car is overloaded, the overcurrent protector automatically disconnects
the circuit (for protecting the circuit); when the circuit fault is removed, the
overcurrent protector automatically connects the circuit.
•
When the battery has power and the car can not run, please check whether the
circuit of the car has an open circuit or short circuit.
