11
ENGLISH
OPERATOR
from the tool and charge it.
Switching operation/action
To start the tool, simply press the switch. The tool speed is increased by increasing the pressure on
the switch. To stop the tool, release the switch.
Switch on the front lamp
ATTENTION:
Do not look directly at the light or light source.
Press the light switch to turn on the lamp. The lamp remains on after the switch is pressed. The light
goes out approximately 5 seconds after the switch is released.
NOTE:
Wipe any dirt from the lamp lens with a dry cloth. Be careful not to scratch the lamp lens as
this will reduce the light.
Reverse switching action
ATTENTION:
Always check the direction of rotation before starting work.
ATTENTION:
Do not use the reverse switch until the tool has come to a complete stop. Changing the
direction of rotation before stopping the tool can damage it.
ATTENTION:
Always turn the reverse switch lever to the neutral position when not in use.
This tool has a switch to change the direction of rotation. Press the reverse switch lever to side A to
rotate clockwise or side B to rotate counterclockwise.
When the rotary selector lever is in the neutral position, the switch button cannot be pressed.
OPERATING MODE SELECTION
NOTE:
Do not turn the operating mode switch while the tool is running. This would cause damage.
NOTE:
To avoid rapid wear of the operating mode mechanism, make sure that the operating mode
change switch is always fully located in one of the mode positions.
Hammer drilling
For drilling in concrete, masonry, etc. Turn the mode switch to the hammer and drill symbol. Use
a carbide tip.
Drilling only
When drilling into wood, metal or plastic, turn the mode switch to the drill symbol in the same way.
Use a twist drill or wood drill.
Cutting
To mow, change to scratch or demolish, turn the mode switch to the mowing symbol. Use a chisel,
cutting tool, etc. Make sure that the chisel is securely fixed in place by turning it slightly.
Adjusting the position of the drill/chisel holder
The drill/chisel can also be locked in various positions. In this way, the optimal working position can
be set for each application. To change the position of the holder lock, proceed as follows:
1. Insert the drill or chisel into the holder.
2. Turn the rotary selector to change the operating mode to the symbol
.
Summary of Contents for AT-CBRH20V
