9
ENGLISH
ASSEMBLY
ATTENTION:
Always make sure that the tool is switched off and the battery is removed before carry-
ing out any work on the tool.
Side (additional) handle assembly
ATTENTION:
Always use the side handle to ensure safe operation.
ATTENTION:
After mounting or adjusting the side handle, make sure that it is securely locked.
Follow the instructions below to install the side handle.
1. Loosen the thumbscrew by turning the side handle counterclockwise.
2. Attach the side handle so that the grooves on the handle fit into the protrusions on the tool cylinder.
3. Turn the side handle clockwise to tighten the thumbscrew and secure the handle. The grip can be
fixed at the required angle.
Depth gauge
The depth gauge is suitable for drilling holes of the same depth.
Loosen the thumbscrew by turning it counterclockwise, and then insert the depth gauge into the hex
hole. Make sure that the toothed side of the depth gauge faces the side handle.
Adjust the depth gauge by moving it back and forth while loosening the screw. After setting the re-
quired depth, tighten the thumbscrew by turning it clockwise to secure the depth gauge.
NOTE:
Make sure that the depth gauge does not touch the main body of the tool during installation.
Lubricant
Pre-coat the end of the drill shank with a small amount of grease (approx. 0.5-1 g). This lubrication
also lubricates the chuck and ensures smooth running and longer life.
Drill assembly or disassembly
Before inserting the drill, clean the end of the drill shank and apply grease.
Insert the drill bit into the tool. Turn the drill bit and push it in until it clicks.
After installing the drill bit, always make sure that the drill bit is securely anchored in place by trying
to pull it out.
NOTE:
Always use an SDS drill. Other types cannot be inserted.
Summary of Contents for AT-CBRH20V
