11
ENGLISH
USE
• Position 2 provides a moderate amount of blade movement.
• Position 3 provides an aggressive fast cut with a rough edge.
SHEET SELECTION AND SETTINGS
Swing ad-
justment
Material
Blade type
TPI (teeth per inch)
0
Worktops, laminated
For wood
10-12
(blade cutting down)
Thin board material
For metal
14-24
1
Plastic/PVC
For wood
10-12
Shaped cuts of wood
Shaped cuts on wood
10-12
2
Plywood, decking, hardwood
For wood
6-12
3
General use/soft wood
For wood
6-10
CUTTING ANGLE ADJUSTMENT
For bevel cutting, the cutting angle can be set on both sides up to 45°.
• Use the enclosed Allen key (14) to loosen the two 3 mm Allen screws (13).
• Slide the saw base (9) back to release it from its current position.
Note:
If using the side guide (8) at the same time, it must be removed beforehand.
• Tilt the base of the saw to the required angle (± 15 °, ± 30 °, ± 45 °).
• Slide the base (9) forward to lock it in place.
• Tighten the locking screws (13).
SIDE GUIDE
If the material is to be cut straight, use a side guide to make the cut easier.
• Insert the side guide through the holes in the base.
• Secure them with the guide adjustment screws (8).
Make a test cut on the rest of the material and adjust the guide more accurately if necessary.
Note:
When not in use, tighten the guide adjustment screws (8) to prevent shock.
DUST EXTRACTION
Inhaling cutting dust can adversely affect your health. Therefore connect a suitable extractor (vacuum
cleaner) to the outlet (12) of the machine.
Note:
A tube diameter adapter may be required for connection.
When using a dust extraction saw, move the switch (11) to the forward position. This opens the chan-
nel, dust is extracted from the saw blade area and the drawn cutting position remains visible. If you
must use the saw without extraction, slide the switch (11) to the rearmost position, which switches the
cooling air from the motor to blow dust out of the blade area so the drawing is visible again.
Warning: All wood dust (including laminate dust, plastics dust, etc.) poses a health risk to the respira-
Summary of Contents for AT-CJS20V
