4
5
Version 2010.
Delivery set:
INSTALLATION
1. Install tray into the intended location and align it
horizontally according to the level. Install siphon and
connect it to the drain pipe. Check water drain.
2. Install wall-mounted profiles (No.1) at the distance
of 890 mm (for model Sence 80 at the distance of
790 mm) from the corner to the center of the holes
of the installation. Fill in the joint between profile
and a wall with a silicone sealer (that meets the
standards of ph-neutrality, colorlessness, antifungal
action) (drw.1).
3. Assemble the screen without doors following
the steps sequence 1 – 6 (drw.2). Insert rollers into
the guides. Place the assembled construction onto
the tray (step 7) and insert into the wall-mounted
profiles. Put decorative inserts onto the glass
profiles (panel profiles) (No.3). Fasten the screen to
the wall-mounted profiles with the help of self-drilling
screws. Fill in the joints with a sealer outside and
inside of the screen (see drw.2).
ATTENTION! After the assembly some time should
be given for the sealer to harden. It is prohibited to
use the product during 24 hours after the finishing of
the installation works.
Cleaning and maintenance of the shower enclosure
- Use soft detergents or soap for cleaning of the
shower enclosure.
- Do not use aggressive detergents for cleaning of
the shower enclosure.
- Severe contaminations on the surface of the
shower enclosure are recommended to be treated
with the diluted vinegar and then rinsed with water.
4. Install the doors onto the rollers that are
preliminary installed into the guides. Arrange doors
alignment adjustment to each other (see drw.3).
5. Install door handles and sealers onto the doors
(drw.4).
DRW.1.
DRW.4.
DRW.2.
DRW.3.
1 – door panel – 2pcs.
2 – roller – 8pcs.
3 – fitting screw – 4pcs.
4 – inner door handle – 2pcs.
5 – outer door handle – 2pcs.
1 – door panel – 2pcs.
2 – roller – 8pcs.
3 – fitting screw – 4pcs.
4 – inner door handle – 2pcs.
6 – sealing bushing – 4pcs.
7 – washer – 4pcs.
8 – decorative stopper of the door handle – 4pcs.
9 – side sealer – 2pcs.
5 – outer door handle – 2pcs.
6 – sealing bushing – 4pcs.
7 – washer – 4pcs.
8 – decorative stopper of the door handle – 4pcs.
9 – side sealer – 2pcs.
