CHAPTER 2: INSTALLATION
THIN-LINE
®
SERIES 180M WELD HEADS
2-2
990-133
Section II. Weld Head Installation
Overview
First, this section will give "Typical Installation" instructions that are common to
all
Series 180M weld
heads. Then, additional instructions for installing
specific
weld head models are listed by model
number.
Before you start installation
:
Read the
Typical Installation
instructions
and
the instructions for the
specific
weld head you
want to install.
Make sure you have all necessary parts and mounting hardware. Use the shipping list as a
reference. Verify that the paper mounting template corresponds to the model number of the weld
head. If you do
not
have the correct template, contact Amada Miyachi America at the address
shown in the front of the manual.
Series 180M weld heads may be purchased with or without mounting hardware. Amada Miyachi
America provides an extruded aluminum post with channels on the front and back. By inserting T
Nuts
into the channels, mounting plates can be screwed onto the front (for weld head), back (for air head), or
both sides of the post (only the weld head is shown). This installation allows you to adjust the height of
the weld head and air head separately.
Typical Installation
Allow about 20.32-25.4 cm (8-10 inches)
between the front edge of the bench and the
stand so the operator can use the bench as a
support when positioning the workpiece.
1
Place the mounting template in the
desired location on the workbench and
tape it in place.
2
Drill the mounting holes as shown on
the template.
3
If necessary, install the weld head
mounting post to the stand.
NOTE:
If you are using optional optics
(microscope/illuminator), install the
optics according to the instructions that
came with the optics.
4
Screw the weld head stand (and optics
baseplate if used) to the workbench.
Summary of Contents for THIN-LINE 180 M Series
Page 1: ...990 133 REV F WELD HEAD THINLINE 180 M SERIES OPERATION MANUAL ...
Page 34: ......
Page 38: ......
Page 42: ......