CHAPTER 3: OPERATING INSTRUCTIONS
THIN-LINE
®
SERIES 180M WELD HEADS
990-133
3-7
5
After setting the required force, particularly in automated applications, remove the force
adjustment knob by loosening the two setscrews, which secure it to the shaft. Invert the knob
and place it on the shaft. Be sure to insert the locking tab on the knob into the slot on the force
tube. Re-tighten both setscrews.
6
If necessary, re-adjust the electrodes in their holders to accommodate the work piece.
7
A down stop is never required when using EZ-AIR. Turn the down stop screws counter-
clockwise to their fullest extension without actually disengaging them. This will allow
maximum downward travel of the upper arms.
Summary of Contents for THIN-LINE 180 M Series
Page 1: ...990 133 REV F WELD HEAD THINLINE 180 M SERIES OPERATION MANUAL ...
Page 34: ......
Page 38: ......
Page 42: ......