Controls and Adjustments
2110A PT Peanut Combine
Elevator Air Control
Manual Elevator Air Control
The elevator air control is normally set so
that peanuts are conveyed about ¾ of the
way across the bin. Make adjustments as
follows:
•
If peanuts are very light or fragile, lower
the air.
•
If the peanuts are very dirty or high yield,
raise the air.
•
Lower the setting if the LSKs or empty
hulls in the bin show excessive shelling
within the conveyor system.
•
Be aware that too low a setting can
quickly stop up the elevator air system.
Automatic Elevator Air Control
As part of the
“Peanut Tech”
package, the
elevator air may be controlled in
auto mode.
When
auto mode
is chosen, the controller
monitors air pressure, combine speed, and
elevator air dampener position to determine
the optimum setting.
As air pressure increases, the damper is
opened and when air pressure decreases,
the damper closes.
The goal is to apply as much air flow as
needed but not so much as to create LSKs.
A
manual mode
option allows the operator
to control the position of the damper from the
cab of the tractor.
For more information, see instructions for the
“Peanut Tech”
package.
NOTE!
On a new machine, or one that
has been sitting idle, some LSKs may be
seen in the bin due to roughness in the
air ducts. Once the air ducts smooth
out, the number of LSKs should
decrease.
54
12/18/15
MAN143
Summary of Contents for 2110A
