2110A PT Peanut Combine
Controls and Adjustments
Standard Pickup Header
Speed Control
Pickup header speed is controlled by your
tractor’s hydraulic remote setting.
Set the header speed so the header picks up
the windrow completely as the combine
travels down the field. If the header is too
slow, it will push the vines along before
picking them up, possibly causing peanuts to
fall off of the vines. If operated too fast, the
windrow will pull apart before entering the
combine and loss could occur.
Dry vines typically require lower pickup
speeds than green vines.
Remote Auger Reverse
Remote reversing auger and header speed
control are standard features built into the
hydraulics package on the AMADAS 2110A.
They function as follows:
•
The remote auger reverse system
consists of a hydraulic reversing valve
and a second hydraulic motor.
•
The valve is installed between the
hydraulic pump system and hydraulic
motors that drive the auger and pickup.
•
When the remote auger reverse is
engaged, the pickup stops and the
header auger reverses, allowing material
jamming the auger to be discharged over
the pickup and onto the ground.
•
There is a hydraulic pressure gauge at
the valve block to indicate system
pressure. Normally, the system operates
in the 1100 PSI range while harvesting.
•
As the header begins to stall (jam), the
pressure should reach 2700 PSI. If the
header is stalling and the pressure gauge
isn’t reaching 2700 PSI, there could be a
problem with the tractor’s hydraulic
system (or the system relief valve on the
optional combine hydraulics system).
WARNING
NEVER remove material from the
header/auger while the tractor engine
and combine are running. Shut off the
tractor before unclogging any part of the
combine. An optional header/auger
hydraulic drive kit is available that is
powered solely by the combine.
IMPORTANT!
Read all hydraulics
safety information in Chapter 1,
Safety
,
before using hydraulics.
NOTE!
If the windrows have excessive
dirt, increase the header speed slightly to
help shake out the dirt before it enters the
machine.
MAN143
12/21/15
55
Summary of Contents for 2110A
