INSTALL FREEZER:
1. Locate the 2 front levelling legs among
the packing materials.
2. Screw these legs into the front holes
on the bottom of the freezer. The back
of the freezer rests on 2 fixed sup-
ports.
3. Adjust the 2 front legs so that the front
of the freezer is slightly higher than the
back. When adjusted properly, the
door will swing shut from 10" open.
4
Installation instructions
REMOVE PACKING
MATERIALS:
Remove materials, tape and labels
before using the freezer.
Do not use sharp instruments, rubbing
alcohol, flammable fluids or abrasive
cleaners. These can damage the
material.
Clean your freezer before using it:
1. Use a sponge, cloth or paper towel
and mild detergent in warm water to
clean outside and inside of freezer,
door liner and gasket.
2. Rinse and dry thoroughly.
CHOOSE FREEZER
LOCATION:
1. Locate the freezer in a safe place,
indoors, away from direct sunlight or
heat sources such as a range, dish-
washer, laundry equipment, heat
vents or radiator.
2.
DO NOT
store flammables such as
gasoline near the freezer.
3. Check the strength of the floor. It
should hold the weight of a fully
loaded freezer.
4. Allow at least 3" (7.5 cm) between top
of freezer and the ceiling.
5. Allow at least 1" (2.5 cm) between
back of freezer and the wall.
6. Allow 3" (7.5 cm) on each side of the
freezer for ease of installation.
7. If the freezer is to be against a wall,
you might want to leave extra space
on the hinge side so the door can be
opened wider.
8. This freezer is designed to operate at
a household temperature of 32° to
110° F (0° to 43° C).
Raise
Lower
