10
Programming Electronic Oven Control
(some models only)
The display
shows
PROGRAM
PROGRAM
PROGRAM
PROGRAM
PROGRAM
.
When PROGRAM pad is
pressed, the display will show
PROGRAM
.
POWER
LEVEL
START/
+30 SEC
Programming Pads
Oven is shipped from factory with pads 1-10 preprogramed. To re-program
pads 1-10 or program pads 11-19, use the following procedures.
1.
Door can be in either open or closed position with
:0
showing in display.
2.
Press PROGRAM pad.
•
PROGRAM
appears in display.
3.
Press desired number pad to be programmed.
• If pad 4 is being programmed,
PROG- -04
will appear in display.
4.
Press POWER LEVEL pad to select desired power level.
• Press POWER LEVEL pad to change power level if desired
(some models).
•
POWER LEVEL
displays.
-
100%
indicates 100% (full) microwave power,
80%
indicates 80%,
60%
indicates 60%, and
40%
indicates 40% microwave
power. By continuing to press the Power level pad, the power level will
cycle through each level continuously.
5.
Press desired number pad(s) to program desired cooking time.
6.
Press START/+30 SEC pad to save programming for
Stage 1.
• If Stage 2 or Stage 3 is desired for programming,
repeat steps 4 through 5.
• If Stage 2 or Stage 3 is not desired press
STOP/RESET pad, to end programming sequence.
NOTE:
If door is closed or STOP/RESET pad is pressed
before programming is complete, changes are
discarded and microwave exits programming mode.
STOP/
RESET
PROGRAM
