6
Display and Features (some models)
START/+30 SEC
Pad
The START/+30 SEC pad is used to
begin a cooking cycle and to
increase the reheat time in 30 second
increments.
• The START/+30 SEC pad is used
to reheat for 30 seconds at 100% (full
power). The oven will start
immediately and 30 seconds will be
added to the time counting down
each time the pad is pressed up to a
maximum reheating time of 5
minutes.
NOTE: Pressing the START/+30 SEC
pad is only available in Manual Time
Entry mode.
STOP/RESET Pad
The STOP/RESET pad stops a cooking sequence in progress
and must be pressed again to clear out any remaining cooking time.
When the STOP/RESET pad is used to end a programming change, the
changes are discarded.
Single Pad Programming
This feature enables each numbered pad to be programmed for a specific
cooking cycle. To use this feature, simply program the pad to the desired
length of time and power level. Press the pad once and the microwave will
begin cooking. Number pads 1-10 are preprogrammed at the factory, but can
be changed.
Double Pad
Programming
This feature enables 10 additional programmed entries to be made. Each entry
will be assigned a double digit number. When using the double pad
programming, a pad must be pressed twice within 2 seconds to start the
cooking cycle.
QTY 2X Pad
The QTY 2X pad doubles the preset cooking time. The QTY 2X pad can be
used with either single or double pad programming. Maximum cooking time is
60 minutes except when cooking with full power (100%). In case of full power
(100%), maximum cooking time is 20 minutes.
Stage Cooking
Stage cooking is a cooking sequence with specific power level and time
changes. The user can program up to three different power level changes and
the specific amount of cooking time at each stage. Each power level/cooking
time combination is known as a stage. Stage cooking is available only on
electronic control models. Maximum cooking time is 60 minutes except when
cooking with full power (100%). In case of full power (100%), maximum
cooking time is 20 minutes.
Program Pad
This feature allows you to program a number pad for a specific power level and
cooking time of your choice in any stage cooking.
Power Level Pad
The POWER LEVEL pad allows you to program a cooking cycle for a specific
power level (100%, 80%, 60%, 40%).
PROGRAM
DEFROST
QTY
2X
STOP/
RESET
START/
+30 SEC
CHECK
PROGRAM
POWER
LEVEL
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
START/
+30 SEC
STOP/
RESET
QTY
2X
PROGRAM
17
7
POWER
LEVEL
STAGE--2
STAGE--3
or
11
1
11
1
