©2006 Maytag Services
16023463
A–15
2004 Amana Commercial Products
Amana, Iowa 52204
Part No. 12878501
Printed in U.S.A. 08/04
Before Calling for Service
To avoid electrical shock which can cause severe personal injury or death, do not remove outer case at any time.
Only an authorized servicer should remove outer case.
Service Codes
During operation, the oven may display a service code.
If this should occur:
1.
Unplug oven and leave unplugged for approximately one minute. Plug
oven in and see if code reappears.
• If code does not reappear, continue normal use with the oven.
2.
If service code reappears, write down the service code displayed and
contact the nearest authorized Amana servicer.
• Do not use oven until contacting the authorized Amana servicer or call
Amana toll free at 1-866-426-2621 inside the U.S.A. or Canada.
ERR
_
Problem
Possible Cause
Oven does not operate.
Confirm oven is plugged into dedicated circuit.
Confirm oven is on grounded circuit.
(Contact electrician to confirm)
Check fuse or circuit breaker.
Oven operates intermittently.
Check air filter and discharge areas for obstructions.
If oven does not accept entries
when pad is pressed.
Make sure oven is on and preheated.
Open and close oven door. Press pad again.
If oven malfunctions or shows
“
ERR
”:
Oven control is equipped with a self-diagnostic system. Self-diagnostic
system alerts you if there is an error or problem. When electronic control
signals a problem, follow steps listed below.
1. Record number shown.
2. Unplug oven, wait for 1 minute, and plug in oven.
• Disconnecting electrical supply may eliminate service code. If failure
continues, contact an authorized Amana servicer or call Amana toll
free at 1-866-426-2621 inside the U.S.A. or Canada.
Oven fan turns on while oven is
not preheating or cooking.
Normal operation. Will run 45 minutes after oven is turned OFF.
"PREHEAT NOT READY"
displays when cook pad is
pressed.
Oven is operating normally. Display flashes "PREHEAT NOT READY" if
the preheat temperature is different than programmed cooking cycle
temperature.
Clean Filtr
displays
This is normal and will appear for 24 hours every 7 days. This is a reminder
to keep the filter clean to keep the oven in peak performance. The
message will turn off by itself; a servicer does not need to be contacted.
HOT
displays
Oven’s magnetron is overheated. Oven automatically interrupts cooking
sequence and turns on cooling fan until normal temperature is reached.
When magnetron cools to normal temperature, oven returns to
READY
mode.
If oven malfunctions or shows
“
ERR9
”:
Oven is overheated. When electronic control signals this problem, follow
steps listed below.
1. Make sure holes in back of oven cavity are clean.
2. Check air filter.
3. Press STOP/RESET pad to clear ERR9.
4. Press PREHEAT ON/OFF pad to restart oven.
• If failure continues, contact an authorized Amana servicer or call
Amana toll free at 1-866-426-2621 inside the U.S.A. or Canada.
WARNING
!