15
RS5280001 Rev. 0
Owner's Manual
Care and Cleaning
WARNING
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before cleaning. After cleaning, connect
power.
Caution
To avoid personal injury or property damage, read and
follow all cleaning product manufacturer's directions.
General
1.
Wash surfaces with 59.14ml baking soda dissolved
in 1.10 liter warm water and a soft, clean cloth.
2.
Rinse surfaces with warm water. Dry surfaces with
a soft, clean cloth.
• Do not use the following items:
- abrasive or harsh cleaners, ammonia, chlorine
bleach, etc.
- concentrated detergents or solvents
- metal scouring pads
These items can scratch, crack and discolor
surfaces.
• Do not place buckets, shelves, etc. in dishwasher.
Odor Removal
1.
Remove all food and disconnect power to
refrigerator.
2.
Clean all interior surfaces including ceiling, floor,
and walls according to “General” instructions. Pay
special attention to corners, crevices, and
grooves. Include all drawers, shelves, and
gaskets.
3.
Connect power to refrigerator and return food to
refrigerator. Wash and dry all bottles, containers
and jars. Wrap foods in tightly sealed containers to
prevent further odor. After 24 hours, check if odor
was eliminated.
Complete the following steps if odor was not eliminated.
4.
Complete steps 1-2.
5.
Place garden fresh crispers on top shelf of Fresh
Food section. Pack Fresh Food and Deepfreeze
®
sections including doors with crumpled sheets of
black and white newspaper.
6.
Place charcoal briquettes randomly throughout
newspaper.
7.
Close doors and let stand 24-48 hours.
8.
Remove charcoal briquettes and newspapers.
9.
Complete steps 2-3.
Contact your Distributor if odor was still not eliminated or
call
001-319-622-5511
outside U.S.A.
Adhesives
1.
Remove glue residue by rubbing toothpaste into
adhesive with fingers until adhesive loosens.
2.
Rinse surface with warm water. Dry surface with a
soft, clean cloth.
Door Gaskets
1.
Clean door gaskets every 3 months according to
“General” instructions.
2.
Apply a light film of petroleum jelly to keep gaskets
pliable.
Condenser Coils
Clean condenser coil every 3 months to ensure
maximum performance of refrigerator. Accumulated dust
and lint may cause the following:
• reduced cooling performance
• increased energy usage
• premature part failure
1.
Remove toe grille by holding ends and pulling
forward.
2.
Clean front surface of condenser coil with a
vacuum cleaner hose nozzle.
3.
Replace toe grille by inserting clips in holes and
snapping in.
Caution
To avoid property damage, protect soft vinyl or other
flooring with cardboard, rugs, or other protective
material. Verify stabilizing leg is raised before moving
refrigerator. Raise stabilizing leg by turning
counterclockwise.
4.
Pull refrigerator away from wall. Run a vacuum
brush across condenser fan outlet grille on back
of refrigerator.
