43
RS5280001 Rev. 0
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a 10,000 ohm resistor before attempting
to service. Ensure all earthing wires are connected before certifying unit as repaired and/or operational.
!
WARNING
Disassembly
Front Roller Assembly
1.
Remove toe grille
2.
Raise front of refrigerator 10cm (4") from floor.
3.
Remove two hex head screws mounting roller
bracket housing.
4.
Remove roller bracket housing from under cabinet.
5.
Remove leveling bolt and disassemble housing
from roller bracket assembly.
Rear Roller Assembly
1.
Remove machine compartment cover.
2.
Raise left or right side of refrigerator 10cm (4") from
floor.
3.
Remove #27 torx bolt going up through rear rail and
into bottom of cabinet foot.
4.
Drop rail slightly and slide roller pin towards outside
of cabinet and out of rail.
Water Valve
1.
Remove machine compartment cover and heat
exchanger cover on rear of unit.
2.
Disconnect water supply.
3.
Remove brass nuts at water valve inlet and outlet.
4.
Pull copper tubing from water valve. Anti-kink
springs are installed in plastic tubing connecting to
valve.
Machine Compartment
1.
Remove machine compartment cover on rear of unit
and heat exchanger cover.
NOTE:
Always recover refrigerants before any sealed
system component repair or replacement.
Replace drier when performing a sealed system
repair with Amana drier.
2.
Remove one bolt from left rear and one bolt from
right rear securing compressor base pan to
cabinet.
3.
Pull compressor base pan slowly towards rear
carefully reforming tubing as necessary to avoid
kinking and pinching.
4.
Pull pan out a maximum of approximately 20cm (8")
from rear. This will allow removing compressor, leak
checking of all condenser joints, and/or replacing or
cleaning condensate pan. Pulling pan out more
than 20cm (8") will drop base pan off front glide rail.
Compressor Run Capacitor (Fan Shroud Mounted)