59
RS5280001 Rev. 0
Kit Instructions
3.
Install the handle (left) side 6.35 mm trim on pre-cut
refrigerator panel.
A.
Be sure front surface of trim piece faces decora-
tor surface of pre-cut panel. Hold trim piece at
an angle along side of panel while aligning end
of trim flush with one edge of panel.
B.
Press and turn front surface of trim around edge
of panel until trim piece fits snugly on edge of
panel.
C.
Repeat Step 3 to install trim on each of the
remaining three (3) sides of the refrigerator
panel.
4.
Install decorator panel on front of refrigerator door.
A.
To prevent scratching refrigerator door when
sliding panel into trim slots, cover outside edges
of rear panel surface with masking tape and put
six (6) evenly-spaced strips of masking tape
across the rear side of the decorator panel.
B.
Slide decorator panel into place.
IMPORTANT:
Permanent-type, double-sided adhesive
tape is attached to
all
trim pieces for easy
installation.
Before
peeling away paper backing
from tape, check the fit of the trim pieces and be
sure you understand how to install each one.
Damage to trim pieces could result if adjustment
or removal is attempted after installation.
5.
Attach handle (left) side trim to refrigerator door.
A.
Remove paper backing from alternating adhe-
sive tape.