67
RS5280001 Rev. 0
Kit Instructions
D.
On the hinge (right) side of the door, use two (2)
Phillips screws to secure trim.
11. Remove refrigerator door stop from bottom of door,
using a Phillips screwdriver to remove two (2) screws.
12. On the side of the door opposite the hinge, use a
Phillips screwdriver to remove and save the two (2)
screws from the bottom of the door.
IMPORTANT:
Permanent-type, double-sided adhesive
is attached to
all
trim pieces for easy
installation.
Before
peeling away paper backing
from tape, check the fit of the trim pieces and be
sure you understand how to install each one.
Damage to trim pieces could result if adjustment
or removal is attempted after installation.
13. Install trim on refrigerator door bottom.
A.
Before
removing paper backing from adhesive,
check the fit by aligning trim snugly on bottom of
refrigerator door.
B.
Align screw holes.
C.
Remove paper backing from adhesive on trim
and press into place.
D.
On the side of the door
opposite
the hinge, use
two (2) Phillips screws to secure trim.
14. Re-install refrigerator door stop, using a Phillips screw-
driver to secure door stop by replacing the two (2)
screws.
IMPORTANT:
Permanent-type, double-sided adhesive
tape is attached to
all
trim pieces for easy
installation.
Before
peeling away paper backing
from tape, check the fit of the trim pieces and be
sure you understand how to install each one.
Damage to trim pieces could result if adjustment
or removal is attempted after installation.