RS5280001 Rev. 0
70
Kit Instructions
21. Remove freezer door stop from bottom of freezer
door, using a Phillips screwdriver to remove and save
two (2) screws.
IMPORTANT:
Permanent-type, double-sided adhesive
tape is attached to
all
trim pieces for easy
installation.
Before
peeling away paper backing
from tape, check the fit of the trim pieces and be
sure you understand how to install each one.
Damage to trim pieces could result, if
adjustment or removal is attempted after
installation.
22. Install trim on freezer door bottom.
A.
Before
removing paper backing from adhesive,
check the fit by aligning trim snugly on bottom of
freezer door.
B.
Align screw holes.
C.
Remove paper backing from adhesive on trim
and press into place.
23. Re-install freezer door stop, using a Phillips screw-
driver to secure door stop by replacing the two (2)
screws.
24. Install trim on freezer door top.
A.
Before
removing paper backing from adhesive,
check the fit by aligning trim snugly on top of
freezer door. Top trim must be tucked under
side trim.
B.
Remove paper backing from adhesive on trim
and press into place.
IMPORTANT:
Permanent-type, double-sided adhesive
tape is attached to
all
trim pieces for easy
installation.
Before
peeling away paper backing
from tape, check the fit of the trim pieces and be
sure you understand how to install each one.
Damage to trim pieces could result, if
adjustment or removal is attempted after
installation.