10
English
1. Remove the upper hinge cover and then using a Phillips screw driver remove the upper hinge bracket
by removing the 4 screws on the bracket. (on the right side).
2. Lift and remove the door.
3. Remove the bottom hinge bracket by removing the 3 hexagonal nuts. Be careful not to loose the
door level rings which are placed in the hinge bracket axle. (right side).
4. Install the bottom hinge bracket on the opposite side (left side).
5. Carefully align the bottom hinge axle hole on the door with the axle of the lower hinge bracket.
Remember to have the door level rings in place before you place the door on its axle.
6. Install the upper hinge bracket (left side hinge bracket supplied as an accessory) on the left side.
7. Make sure the door is aligned and then tighten the screws.
8. Remove and reinstall the door handle on the opposite side.
Replacing Light Bulb
1. Turn off and unplug the power cord of the wine cellar.
2. Remove the light bulb cover.
3. Make sure the light bulb is cool before removing it. Replace using a 10 watts light bulb.
4. After the bulb is secure, install the light bulb cover.
5. Turn unit on to its original setting after plugging in the power cord.
