3
INSTALLING YOUR FREEZER
Unpacking
Remove Packaging Materials
■
Remove tape and glue residue from surfaces before turning on the
freezer. Rub a small amount of liquid dish soap over the adhesive
with your fingers. Wipe with warm water and dry.
■
Do not use sharp instruments, rubbing alcohol, flammable fluids,
or abrasive cleaners to remove tape or glue. These products can
damage the surface of your freezer. For more information, see the
front cover for safety instructions.
Clean Before Using
After you remove all of the packaging materials, clean the inside of
your freezer before using it. See the cleaning instructions in “Caring
for Your Freezer.”
Location Requirements
Ventilation and Clearance
■
Keep flammable materials and vapors, such as gasoline, away
from freezer.
■
Do not cover the freezer with items such as blankets, sheets,
tablecloths, etc. This reduces air circulation.
■
Allow at least a 3" (7.5 cm) clearance on both sides of the freezer
and 2" (5 cm) between the back of the freezer and the wall. Leave
room above the freezer to open the lid.
Temperature
Your freezer operates most efficiently when located in an area where
the temperature is normally between 32°F (0°C) and 110°F (43°C).
Place your freezer in a location where the temperature will fall
between the low and high recommended temperature.
Upon Moving to Final Location
■
Level the freezer from side to side and front to back so that the lid
will seal properly. Use shims to level the freezer if necessary.
NOTE:
It should not be necessary to remove the lid during
installation. If, for any reason, the hinges need adjustment,
contact a designated service company.
Electrical Requirements
Before you move your freezer into its final location, it is important to
make sure you have the proper electrical connection.
Recommended grounding method
A 115 V, 60 Hz, AC only, 15 or 20 A fused, grounded electrical supply
is required. It is recommended that a separate circuit serving only
your freezer be provided. Use an outlet that cannot be turned off by a
switch. Do not use an extension cord.
WARNING
Excessive Weight Hazard
Use two or more people to move and install freezer.
Failure to do so can result in back or other injury.
When Moving Your Freezer:
Your freezer is heavy. When moving the freezer for cleaning
or service, be sure to cover the floor with cardboard or
hardboard to avoid floor damage. Always pull the freezer
straight out when moving it. Do not wiggle or “walk” the
freezer when trying to move it, as floor damage could occur.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from freezer.
Failure to do so can result in death, explosion, or fire.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
2" (5 cm)
3" (7.5 cm)
