- 14 -
○
1 ,
○
2 ,
○
3 and
○
4 , driving a warp of the mirrors to the outer areas. When still a
warp remains, loose some of nearby screws for adjustments, and tighten them fully again.
NOTE!
Any of Incorrect bent-lines, mentioned as a
NOTE!
in
Step 4.1
(Page 9), makes
it impossible to avoid warping. In that case, you must adjust incorrect lines.
6. Mounting the Core Bar Assy.
Fig. 47
All of four clicks of the Bush
○
10 must hold the hole-edge.
1. Place one of the Bushes
○
10 on the hole in the
KARU Mirror
○
8 at the
○
4a side.
○
4a side
See
Figs. 47
and
48
.
2. Insert the end of the Core Bar Assy. into the hole edged with the bush on the mirror
surface.
At first, insert the end with a washer deep into the hole on the parabola, and then move
the assy. horizontally to insert the end of
○
2 into another hole on the opposite side
Clicks of the Bush
○
10 face outside. (Both of the Position A and B.)
*
The concave Bar comes front.
○
2
Position B / C
!
DO NOT hit the Mirror surface!
○
10
○
7b
○
4a side
○
4b side
⑧
⑧
*
The oval hole comes near.
○
47
○
42
Screws inside the dotted lines must
be stainless steel made ones
○
47 .
○
2
○
33
*
The concave Bar comes front.
○
10
Position A
Fig. 48
The Angle Setter faces the direction opposite
to that of
the Position B and C
NOTE!
Be careful not to hit the Mirror surface with the Spacer Sleeve
○
16 ,
when inserting it.
All manuals and user guides at all-guides.com