11
EN
Problem
Possible Cause
Solution
Machine will not start
No power
Check the main power supply (building circuit breaker).
Check the cord connection at the wall outlet
Switch lever safety lock not
depressed
Hold in the switch lever safety lock and then engage
switch levers.
Bad connection
Check the motor and cord interlock connections.
Bad motor speed selector
switch
Change the motor speed. If motor runs, change the
speed selector switch.
Defective Switch
Check and replace if necessary.
Motor runs sluggish
Low voltage
Using extension cord with wire smaller than 10/3.
Replace with a 10/3 extension cord.
Using more than one extension cord. Only use one 50ft
10/3 extension cord.
Electrically connect to American Sanders Power
Booster.
Motor carbon brushes are worn Check and replace if necessary.
Defective handle switch
Check and replace if necessary.
Bad rectifier
Contact an authorized American Sander Dealer.
Fuse / circuit breaker repeatedly trips
Low voltage
Eliminate extension cord & locate a power source closer
to work site.
Have voltage checked by a qualified electrican.
Electrically connect to American Sanders Power
Booster.
Not on a dedicated circuit
Make sure there is no other items using power on the
circuit.
Motor is overloaded
Remove weights.
Switch to high speed, especially if using paper lower
than 100 grit or if removing finish.
Bad connection
Contact an authorized American Sander Dealer.
Defective motor
Contact an authorized American Sander Dealer.
Machine wobbles during operation
Defective pad
One side is more dense than the other. Replace pad.
Machine left setting on pad for
extended time
Pad has taken "a set". Replace pad.
Warped block on brush or
padholder
Check and replace if necessary.
Block not installed properly
Remove and install properly.
HydraSand head damaged.
Inspect head and repair or replace
Light does not work
Light switch not turned "ON".
Turn "ON" light.
Light damaged
Check and replace if necessary.
Maintenance
Summary of Contents for American Sanders Epoch HD
