11
Machine Troubleshooting
Problem
Possible Cause
Solution
Check the main power supply (building circuit breaker).
Check the cord connection at the wall outlet
Switch lever safety lock not depressed
Hold in the switch lever safety lock and then engage switch levers.
Bad connection
Check the motor and cord interlock connections.
GFCI tripped
Push the reset button. If problem continues, contact an authorized APEC distributor
Bad motor start capacitor
Contact an authorized APEC Distributor.
Defective motor start switch
Contact an authorized APEC Distributor.
Using extension cord with wire smaller than 12/3. Replace with a 12/3 extension cord.
Using more than one extension cord. Only use one 50ft 12/3 extension cord.
Bad motor run capacitor
Contact an authorized APEC Distributor.
Defective handle switch
Contact an authorized APEC Distributor.
Eliminate extension cord & locate a power source closer to work site.
Have voltage checked by a qualified electrican.
Not on a dedicated circuit
Make sure there is no other items using power on the circuit.
Try a different driver/head that is less aggressive.
DO NOT add weight to machine. Remove any excess weight added to machine.
Bad connection
Contact an authorized APEC Distributor.
Defective motor
Contact an authorized APEC Distributor.
Defective pad
One side is more dense than the other. Replace pad.
Machine left setting on pad for extended time
Pad has taken "a set". Replace pad.
Warped block on brush or padholder
Replace.
Block not installed properly
Remove and install properly.
No power
No power
Low voltage
Low voltage
Machine wobbles during
operation
Machine will not start
Motor runs sluggish
Fuse / circuit breaker
repeatedly trips
Motor is overloaded
Scheduled Maintenance
Daily
Weekly
Monthly
Every 6
Months
Annually
Empty the water tank
Remove driver / pad holder
Check for loose or lost fasteners
Inspect hoses and connections
Inspect driver / pad holder for damage
Clean the machine and accessories
Test the GFCI
Check the power cord for damage
Check machine wiring for fray or cut
Interval
These items must be performed with the proper tools and training. Contact an Amano Pioneer Eclipse
Factory Certified Technician unless you have the proper equipment and mechanical proficiency.
Operation
