3
IMPORTANT INSTRUCTIONS
Read all instructions before installing or using this heater.
2.
Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at
least 3 feet from the front of the heater; keep them away from sides and rear as well.
3.
Always unplug heater when it
’
s not in use.
4.
Do not operate the fireplace if it has a damaged cord or plug, after it has malfunctioned, or if the
unit has been dropped or damaged in any way.
5.
Never place the heater where it may fall into a bathtub or other water containers.
6.
Do not run the cord under carpeting. Do not cover the cord with throw rugs, runners or anything
else. Arrange the cord away from traffic areas where it could not be tripped over.
7.
To disconnect the heater, turn the controls to "OFF" before removing the plug from the outlet.
8.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may
cause an electric shock, fire or damage to the heater.
9.
To prevent a possible fire, do not block air intakes in any manner.
10.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint
or flammable liquids are used or stored.
11.
Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock or injury to persons.
12.
Avoid the use of an extension cord because the extension cord may overheat and cause a fire.
13.
Always use properly grounded fused and polarized outlets.
14.
Always use ground fault protection where it is required by electrical codes.
15.
Always disconnect the power before performing any cleaning, maintenance or relocation of the
heater.
16.
To prevent a possible fire, do not burn wood or other materials in this heater.
17.
To prevent electric shock or fire, always use a certified electrician, should new circuits or
outlets be required.
When transporting or storing the heater, keep it in a dry place, free from excessive vibration.
1.
18.
Summary of Contents for BI-40-DEEP
Page 15: ...4 Bend up the framing plates 5 Put the unit into the opening 15 ...
Page 24: ...24 EXPLODED VIEW ...
Page 27: ...27 ...
