01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
REMOTE CONTROL OPERATION
You must press the key to open the remote control and press the key to enter the setting current time state.
When one of the “Sun”“ Mon”“Tue”“Wed”“Thu”“Fri”“Sat” date is flashing, you can press the or key to select the
current day of the week, and press the key to confirm and enter hour setting
.
When the digital tube of time hour
flashes, press the or key to set the current time and press the key to confirm and enter minute setting.
When the digital tube of time minute flashes, press the or key to set the current time and press the key
to confirm.
This Power Button turns the fireplace on and off. It has a memory
function, press the power button once to turn power on. Pressing the
power button again will turn the power off.
The Timer Button has adjustable setting at range from 30 minutes to 8
hours. As shown the following: 0:30- 1:00- 1:30- 2:00- 2:30- 3:00-
3:30- 4:00- 4:30- 5:00- 5:30- 6:00- 6:30- 7:00-7 :30- 8:00. Once you
have set the timer, The icon will be displayed on the LCD screen
of the remote control. Press this button again, cancel the timing
setting, and the icon disappears.
When the timer is up, it will close all the functions and enter standby
mode. In this mode, you should touch the power icon to restart the
appliance.
Each time the Heater Button is pressed, the power of the heater will
change. As shown the following: H1- H2- AUTO(22
℃
)- OFF(no
display).
H1 means the fireplace on Low Heat.
H2 means the fireplace on High Heat.
AUTO means fireplace can automatically adjust to the temperature
you set. When in AUTO
,
you can set the desired temperature with
0
or keys. You can switch temperature unit between Celsius
and Fahrenheit with or keys.
Setting the current time of the remote control
For the remote to function make sure the fireplace is plugged in and
the ON / OFF Power Switch on the fireplace is in
the ON position and
the remote has batteries.
Important:
When operating the remote make sure you point the remote to the center of the fireplace. Each time you
press the button, there will be a beep tone emitted.
