01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
INSTALLATION- BUILT-IN
Preparation
NOTE: Due to the many different materials used to build walls, it is highly recommended that you consult your local
builder before you install this appliance on a wall.
1. Select a location that is not prone to moisture and is located at least 0.91m or 3 feet away from combustible materi-
als such as curtains, drapes, furniture, bedding, paper,etc.
2. Mark the desired location on the floor and store the appliance in a safe, dry and dust free place.
3. Prepare a wall with a framed opening to accommodate the size of your unit. Leave at least 1/4” (6mm) around the
edge of the applicnce. Any new wiring must be done in compliance with local and national codes and other applicable
regulations.
1. Unscrew 4 screws on the top, 4 magnets are at the bottom
（
The quantity varies depending on the size of the unit
）
and take off the trim. (NOTE: Keep hold of the front glass as it may fall down automatically when the trim is removed.)
2. Carefully remove the front glass panel once the trim
has been removed. Use caution as the glass is now
loose.
3. Unscrew the screws located on each side and
take off the inner side steel panels.
Magnetic Stones located here
Screws Located Here
