INSTALLATION- BUILT-IN
NOTE: Due to the many different materials used to build walls, it is highly recommended that
you consult your local builder before you install this appliance on a wall.
Preparation
1. Select a location that is not prone to moisture and is located at least 0.91m
from combustible materials such as curtains, drapes, furniture, bedding, paper, etc.
2. Mark the desired location on the floor and store the appliance in a safe, dry and dust free
place.
3. Prepare a wall with a framed opening to accommodate the s
least 1/4” (6mm) around the edge of the appliance. Any new wiring must be done in
compliance with local and national codes and other applicable regulations.
Prior to installing, test the appliance to make sure the appliance is fu
plugging the power supply cord into a 120 Volt grounded outlet.
The rough wall opening size of the fireplace:
16
IN
: Due to the many different materials used to build walls, it is highly recommended that
you consult your local builder before you install this appliance on a wall.
Select a location that is not prone to moisture and is located at least 0.91m
from combustible materials such as curtains, drapes, furniture, bedding, paper, etc.
Mark the desired location on the floor and store the appliance in a safe, dry and dust free
Prepare a wall with a framed opening to accommodate the size of your unit. Leave at
least 1/4” (6mm) around the edge of the appliance. Any new wiring must be done in
compliance with local and national codes and other applicable regulations.
Prior to installing, test the appliance to make sure the appliance is fully operational by
plugging the power supply cord into a 120 Volt grounded outlet.
The rough wall opening size of the fireplace:
: Due to the many different materials used to build walls, it is highly recommended that
you consult your local builder before you install this appliance on a wall.
Select a location that is not prone to moisture and is located at least 0.91m or 3 feet away
from combustible materials such as curtains, drapes, furniture, bedding, paper, etc.
Mark the desired location on the floor and store the appliance in a safe, dry and dust free
ize of your unit. Leave at
least 1/4” (6mm) around the edge of the appliance. Any new wiring must be done in
compliance with local and national codes and other applicable regulations.
lly operational by
INSTALLATION
Screw locations
Magnetic stone locations
Log set
1. Unscrew 4 screws to take off the trim and get out the log set. (NOTE: Keep hold of the
front glass as it may fall down automatically when the trim is removed.)
W(“)
D(“)
H(“)
SYM-34(SM-190034-1)
32 7/8
6
16
SYM-42(SM-190042-1)
42 3/4
6
16
SYM-50(SM-190050-1)
50 3/4
6
16
SYM-60(SM-190060-1)
60 3/4
6
16
SYM-74(SM-190074-1)
74 3/4
6
16
SYM-88(SM-190088-1)
88 3/4
6
16
SYM-100(SM-1900100-1)
100 3/4
6
16
Summary of Contents for SM-1900100-1
Page 34: ...EXPLODED VIEW 34 ...
