27
OPERATION
The fireplace can be operated either by the switches located on the left bottom of the
fireplace unit or by supplied remote control.
Plug the fireplace into a 15 Amp wall socket.
MANUAL OPERATION
1. Press the
Heat
button repeatedly to set the heater to desired heat setting. The heater
indicator LED will glow which shows the current heater settings.
a) RED 1200W HEAT OUTPUT
b) BLUE 600W HEAT OUTPUT
c) PURPLE AUTO MODE
AUTO MODE
Under this mode the heater will automatically turn ON at high heat setting 1200W heat output
when the room temperature drops below 22
(72
). When the room temperature is between
℃
℃
22-25
(72
℃
-77
) the heater output will switch to low heat setting
℃
600W. When the room
temperature goes above 25
(77
) the heater will be turned off and the
℃
℃
cycle will continue.
The LED indicator will be PURPLE in colour under this mode.
2. Flame effect: Press the button marked
Flame
to adjust the flame brightness. The flame
brightness will cycle through –Low–Medium–High–OFF.
NOTE:
If operated at the Low heat setting, the fireplace will not provide as much heat
output as in the High heat setting, however the low setting will not require as much electrical
power to operate.
To avoid overloading a circuit, do not plug the fireplace into a circuit that already has other
appliances working. When the fireplace is not in use switch off and unplug.
SAFETY CUT-OFF
This appliance is fitted with a safety cut-off which will operate if the fireplace overheats
(e.g. Due to blocked air vents). For safety reasons, the fireplace will NOT automatically
reset.
To reset the appliance, disconnect the appliance from the main supply for at least 10
minutes. Reconnect the supply to the main and switch on the appliance.
Summary of Contents for SYM-100-B
Page 32: ...EXPLODED VIEW 32 ...
