19
REMOTE CONTROL OPERATION
For remote to function make sure the heater is plugged in
and the main power switch located on the bottom left hand
side is at position I.
Important: When operating the remote make sure you point
the remote to the center of the fireplace each time you press
the button. There will be a beep tone emitted. There can be a
slight delay for the receiver to respond to the transmitter. Do
not PRESS the buttons more than once within two seconds
for correct operation.
Power on
The power-on button at top left corner of the remote
is the mains ON/OFF power button. This will turn off
all the functions and the fireplace will be in standby
mode.
DISPLAY ON/OFF
Turns the fireplace flame and tray light ON/OFF. It
will recall the last settings used on the fireplace.
BLUE
Each click adjusts the intensity of the blue flame. Use
alone or in addition to yellow and/or orange.
YELLOW
Each click adjusts the intensity of the yellow flame.
Use alone or in addition to blue and/or orange.
ORANGE
Each click adjusts the intensity of the orange flame.
Use alone or in addition to yellow and/or blue.
MOOD LIGHT
ON/OFF
Turns the ambient canopy lighting ON/OFF
ADJUST
Rotates through the 13 colors of the ambient canopy
lighting.
FLASH
Turns the mood light into flash mode, this cycles
through all 13 mood light colors.
HEATER ON/OFF
Turns the heater ON/OFF. It will recall the last
settings used on the fireplace.
HIGH
Press the high button to switch the heater to high
heat setting 1000W
LOW
Press the low button to switch the heater to low heat
setting 500W
TEMP
Each click adjusts the temperature range from 18°C -
28°C (64°F - 83°F). Once the desired temperature is
chosen, the fireplace will maintain the tempe/-
2°C
