4
·
Do not lift the appliance by the front panel.
·
Keep hot air outlet at least 1 meter away from ceiling.
CAUTION:
In order to avoid a hazard due to inadvertent resetting of the thermal
cutout, this appliance must not be supplied through an external switching device, such
as a timer, or connected to a circuit that is regularly switched on and off by the utility.
Getting Started
·
Remove the appliance from the box.
·
Remove any packaging from the product.
·
Place the packaging inside the box and either store or dispose of safely.
Contents of Carton
·
Heater.
·
Wall fixing bracket.
·
Fixing screws and wall plugs.
·
Remote control.
·
1 Instruction Manual.
Helpful Advice Before Fitting
·
Please retain all packaging until you have checked and counted all the parts and the
contents of the fixing pack against the parts list.
·
The fixing pack contains small items which should be kept away from young children.
·
We suggest that you open the fixing pack and place all the contents into a container,
therefore reducing the risk of losing any small pieces.
Installation
·
Do not connect the appliance until properly fixed to the wall and the instructions is read fully.
·
The minimum distances must be observed.
·
For installation of the appliance, care must be taken not to damage concealed cables.
·
Please be careful while drilling the holes.
·
This appliance is designed to be permanently fixed to a wall at a minimum height of
300mm.The wall bracket must be fitted horizontally and the cable routed to the bottom right
of the heater.
·
A height of 600mm from bottom of heater to floor is recommended for optimum viewing of
fuel bed
（
see Fig.2 for recommend fixing dimensions
）
.
·
For optimum viewing, mark the top four screws fixing positions on wall in accordance with
the recommend fixing dimensions- see Fig.2.Drill holes with a six drill bit.
·
Fix the wall bracket using that the plug and screws provided .
·
Carefully lift the heater up ensuring that the top rear ledge of heater engages the wall bracket
(see Fig.2 in circle) and is sitting centrally.
·
Gently bring the heater level with the wall.
·
Mark the bottom holes position-see Fig.3, remove the heater ensuring that the bottom fixing
Summary of Contents for WM-3522CF
Page 2: ...2...
