5
bracket is rotated up.
·
Drill and fit wall plug.
·
Refit the heater to the wall fixing bracket and rotate the bottom fixing bracket down again and
use the screw provided to permanently fix the heater in place.
·
Unpack the pebbles from the bag and place them along the light unit in the desired
Position.
·
Place the front glass surround over the front of the fire aligning the slots in the brackets at each
side of the glass panel with the lugs on the sides of the fire-see Fig.4. Again two people
will be required for this operation.
Instructions for Use
·
The appliance can be operated either by the switches located on the top right hand
side of the fire or by supplied remote control.
Manual Operation
·
The switches located at the top right hand side of the fire .The standby switch must be first
switch on..
·
Press once the O/I button to turn on the appliance and fire effect.. A red indicator light will
appear to indicate that the function is ON. Press the O/I button for 3 seconds this will operate
the dimmer mode.
·
Press once the 750W button for the low heat settings; press twice to switch off the heat setting.
·
Press once the 1500W button for the high heat settings; press twice to switch off the heat
setting.
Remote Operation
·
The standby switch located at the top right hand side of the fire must be first switch on..
·
It takes some time for the receiver to respond to the transmitter. Do not PRESS the buttons
more than once within two seconds for correct operation.
·
Press once the button ON/OFF on the remote control this turns ON/OFF the appliance and fire
effect.
·
Press once the 750W button for the low heat settings; press twice to switch off the heat setting.
·
Press once the 1500W button for the high heat settings; press twice to switch off the heat
setting.
·
Press the DIMMER button for operate the dimmer mode.
Safety Cut-Off
·
This appliance is fitted with a safety cut-off which will operate if the fire overheats (eg.
due to blocked air vents). For safety reasons, the fire will NOT automatically reset.
·
To reset the appliance, disconnect the appliance from the mains supply for at least 15
minutes. Reconnect the supply to the mains and switch on the appliance.
Summary of Contents for WM-3522CF
Page 2: ...2...
