INSTALLATION- BUILT-IN
1.
Select a location that is not prone to
moisture and is located at least 0.91m or 3
feet away from combustible materials such
as curtains or drapes, furniture, bedding,
paper, etc.
2.
Mark the desired location on the floor and
store appliance in a safe, dry and dust free
location.
3.
Prepare a wall with a framed opening to
accommodate the size of your unit. Leave at
least 1/4
”
(6 mm) around the edge of the
appliance. Any new wiring must be done in
compliance with local and national codes
and other applicable regulations.
Note
: Fireplace must stick out of the wall a
minimum of 1/2
”
or 1.5 cm.
Prior to installing the appliance, test to make
sure the appliance operates properly by
plugging the power supply cord into a
conveniently located 120 Volt grounded
outlet.
The rough wall opening size of the fireplace:
W(
“
)
D(
“
)
H(
“
)
WM-FM-26-3623-BG
27
6 1/2
20 1/2
WM-FM-34-4423-BG
35
6 1/2
20 1/2
WM-FM-48-5823-BG
49
6 1/2
20 1/2
WM-FM-60-7023-BG
60 5/8
6 1/2
20 1/2
WM-FM-72-8123-BG
72 1/2
6 1/2
20 1/2
WM-FM-88-10023-BG
89 1/2
6 1/2
20 1/2
1.
Take the front glass off from the unit. Put the
brackets on the both sides and top of the fireplace
as shown blew.
2.
Lift fireplace and insert into opening.
3.
Make sure that the power supply port is not
behind the wall.
4.
Level the fireplace.
5.
Drive mounting screws into the mounting
brackets on the unit and the wall studs.
6 Replace glass and plug in back-lighting
.
LED. See page 11.
NOTE: Due to the many different materials used on different walls, it is highly recommended
that you consult your local builder before you install this appliance.
14
Summary of Contents for WM-FM-26-3623-BG
Page 26: ...EXPLODED VIEW 26...
