Preface
Caution
1. Make sure the record cleaner is placed on a clean, stable surface before use.
2. Make sure the power cord is plugged into the record cleaner properly and that the
power cord is not pinched and tangled.
3. Be careful when always apply cleaning fluid. Excessive liquid will cause it to spill.
4. Do not leave the machine during operation, and do not allow the machine to start
unattended.
5. Make sure the record is spinning before turn on the vacuum pump and that the
cleaning fluid must be applied on records already. The vacuum pump should only be
used when the record is wet.
6. There are no parts inside the machine that the customer can service or replace. If
the machine is disassembled, the warranty will be void.
7. The vacuum pump must not be turned on for more than 20 minutes per
continuous operation. Allow sufficient cooling between each operation.
Reminder
1. Do not tilt the brush so the aluminum part of the brush touches the surface of the
record.
2. Ensure that the record clamp is tightened properly before using the vacuum
pump.
3. It is best to use a plastic squeeze bottle for applying cleaning fluid onto the
record.
4. The cleaning actions run on this cleaner cannot repair serious damage and
scratches on the surface of the record.
5. When using cleaning fluid from different manufacturers, it is recommended to
read the corresponding instructions carefully before using them.
