RW-600 Record Cleaner
4. Remove the filter sponge cover
(12)
, first take out the filter sponge, add 15 to
20ml of Amari Record Cleaning Fluid and then add about 4.5 liters of distilled water,
observe cleaning fluid level display
(6)
until the level switch float position is close to
the upper fluid level switch position. When the green LED lights up, stop adding
cleaning fluid. Insert filter sponge and put on cover.
5. Without putting in a record, press the red start button
(4)
which initiates the
cleaning simulation process. The yellow LED lights up, and the cleaning process
automatically operates for one cycle and it will take about 6 minutes. When the
green LED light is on, the buzzer sounds and the analog cleaning is completed in
one cycle!
At this time, the equipment is ready for cleaning.