22
Graphic 10
5.10 Exciter Lubrication
See Graphic 11
Adjust to a full load speed of 3600 ± 100 rpm. To adjust engine speed:
The bearings in the exciter assembly are splash lubricated and rotate at very high speed. It
is important to maintain the exciter oil at the correct level and change it regularly.
Check oil level in exciter every 50 hours of operation.
To check oil level, place plate on a flat, level surface. Remove the drain plug (
a
) with seal
ring (
b
). Oil level should be at drain plug threads. Add oil as required.
Change exciter oil every 300 hours of operation.
To drain oil, remove plug (
a
) from end of exciter and tilt plate up.
Note: In the interests of environmental protection, place a plastic sheet and a container
under the machine to collect any liquid which drains off. Dispose of this liquid in accordance
with environmental protection legislation.
Place plate on a level surface and add oil through plug opening until oil reaches the drain
plug threads.
See Technical Data.
Notice
:
DO NOT
overfill. Too much oil in the exciter can reduce performance and damage
the drive belt.
Summary of Contents for PDZ1240
Page 8: ...7 2 5 Label Locations Graphic 1...
Page 27: ...26 5 15 Parts List...
