7
Step D:
Measure a small, medium, and large hook against the back of the notebook tray and
docking station, then pick the hook that fi ts around it best. One at a time, loosen the top mounting
screws on the arm, then slide the hook around the screw and your docking station. Tighten the
mounting screw to hold the hook in place.
NOTE
: You can also remove a mounting screw to attach the cable clip.
Step 4: Adjust your arm’s tension
Adjust your notebook mount’s tension. You can adjust the vertical, tilt, and arm tension so that the
notebook stays in place when you move it.
Adjusting the vertical tension
Tilt the notebook down to access the screw. If the notebook is rising up, loosen the screw by
turning it to the left. If the notebook is falling down, tighten the screw by turning it to the right.
Caution:
Do not over-tighten the screw. You might damage your notebook mount.
