24-Sheet Cross-Cut Paper, CD
and Credit Card Home Office
Shredder with Pullout Basket
B07WJ4NLFX
Min
50
WARNING: DO NOT ATTEMPT TO REPAIR BY OPENING THE SHREDDER HEAD. THIS WILL COMPLETELY VOID THE PRODUCT WARRANTY.
!
TROUBLESHOOTING GUIDE
1)
Make sure power cord is plugged
into a functioning 120V standard
household power outlet.
Or, try using a different working
outlet.
2)
• Check if the green Power On
icon is lit.
• Check the bin is not open.
1)
If Overheat icon is lit in red, turn
shredder off and let it cool down for
50 minutes. Turn shredder on, check
icon light again, and restart shred-
ding only when icon light is not lit.
2)
The Red LED light indicates when
too much paper is inserted. Use the
“Reverse” mode to back up and
reduce number of sheets.
3)
If Door Open icon is lit in red,
re-close door until you feel firm click
and Door Open icon is not lit.
4)
If Bin Full icon is lit in red, empty bin.
5)
If the LED Power On green light is
not on:
• Make sure power cord is plugged
into a working outlet.
No-power to the shredder
1)
Unplug the machine from the wall
socket.
2)
•
Find the activation sensor in the
center of the feed slot.
•
Use a cotton swab to gently wipe
away any dust or debris that has
collected on the sensor.
Warning:
DO NOT USE CANNED AIR.
!
Cotton swab
Unplug power
Clean sensor
Feed in the center
Shredder does not feed or shred paper
Overheat
Overload
Door open
Bin full
Power light not on
Cool down
Reduce sheets
Close door
Empty Bin
Shredder runs continuously
EN
Reverse to remove paper
Turn off shredder
Turn on power
Use thick paper to push
jam through
Apply shredder oil and
wait for 30 min
Reduce sheets to
resume shredding
Shredder is Jammed or runs in “reverse” mode only
Pull up
Min
30
Shredder does not feed or shred credit card or small piece
of paper
• Position credit card or small piece of
paper over the credit card section of
the Feeder (center position).
•
Try again.
Warning: DO NOT USE ANY
SPRAY CANS OR AEROSOLS.
!
1)
• Set the control switch to reverse.
• Pull the paper to remove jammed
paper (as much as possible).
2)
• Turn off shredder.
• Apply shredder oil to the feed slot.
• Let oil soak in to paper and
machine for 30 minutes.
Note: 1. Repeat 1 & 2 steps if
needed
2. Shredder oil not
included.
3)
• Set the power switch to turn on
shredder.
• Use thick paper stock or a
greeting card to push the jam
through.
4)
• Reduce the number of sheets
being fed (count pages to be sure
not to exceed the maximum sheet
count).
• Refeed the paper.
Check power outlet
Check power light
