Settings
38
A BAH0040-9 01.19
8. Press
.
9. Press the
or
button.
Enter the scale value of the pointer (e.g. 50, refer to the seed drill operating manual) for the first
calibration test (Fig. 31/2).
10. Press
.
11. Press the
and
buttons simultaneously.
The pointer (Fig. 31/2) moves to the scale value entered (e.g. 50).
The scale value must be the same as the gearbox setting value
displayed on the control terminal.
If not, the Vario gearbox will need to be calibrated (see section
"Calibration of the Vario gearbox", Seite 29).
12. Start with the crank turns for the calibration test.
13. Stop the cranks when you hear an acoustic signal, then press the
button.
In its calculations, the A takes account of the additional rotations after the acoustic
signal.
14. Weigh the collected seed quantity.
15. Press the
or
button.
Enter the weight [kg] of the collected seed quantity.
16. Press
.
Save the value.
The A calculates the required gearbox setting based on the data from the calibration test.
The pointer (Fig. 31/2) moves to the calculated scale value.
17. Repeat the calibration test with the last gear setting to verify it is correct.
Summary of Contents for AmaDrill+
Page 23: ...Layout and function AMADRILL BAH0040 9 01 19 23 Fig 16 ...
Page 70: ......
Page 71: ......
