The application map will be loaded.
NOTE
For the application map to be properly displayed,
the following conditions must be fulfilled:
The
"Application map"
must be selected as the
"Coverage map"
The controllable implement element must be
selected as the VRC map; see page 211
The coverage scale must be configured; see
page 212
2
Adding an application map to a job
REQUIREMENTS
The USB stick with the application maps in shape
format is inserted into the AMAPAD.
NOTE
Application maps must be created with the
WGS-84 coordinate system.
Application maps consist of 3 files. All 3 files
must be saved in the same folder on the USB
flash drive:
Geometry data file, file format: .shp
Factual data file, file format: .dbf
Attribute data file, file format: .shx
NOTE
If an application map has already be loaded for the
job, a different job must be selected or created.
1. In the job menu, tap on
.
2. Call up the
"Rate control assignment"
menu with
.
002731
Q | Using rate control| Adding an application map to a job
MG5574-
EN
-II | B.1 | 25.10.2016
196
