8. Under
"Setpoint"
, enter the value for the rate that
should be applied when the sensor does not transmit
any data.
9. Under
"Out of field value"
, enter the value for the
rate that should be applied when the implement
crosses the boundary line.
10. Under
"Position lost value"
, enter the value for the
rate that should be applied when the GPS signal is
interrupted.
11.
To document product information,
12. Confirm with
.
The application map will be loaded.
NOTE
For the application map to be properly displayed,
the following conditions must be fulfilled:
The
"Application map"
must be selected as the
"Coverage map"
The controllable implement element must be
selected as the VRC map; see page 211
The coverage scale must be configured; see
page 212
5
Configuring rate control
5.1 Editing the fallback value
For certain situations, fallback values can be edited for
the application rate. The fallback values that can be
edited depend on the signal source used.
048408
060593
Q | Using rate control| Configuring rate control
MG5574-
EN
-II | B.1 | 25.10.2016
203
