3. Confirm restart with
.
4. Tap on
"Implement name"
.
NOTE
Sensible implement names should be assigned to
make it easier to manage the implements.
5. Enter the name.
6. Confirm the entry with
.
The implement setup assistant will be shown.
7. In Step 1, select
"Part-width section control and rate
control"
under
"Implement control"
.
8. In Step 2, select
"ISOBUS"
under
"ECU type"
.
9. In Step 3, select the type of the connected
implement under
"Implement function"
.
10. In Step 4, select the connected implement from the
list under
"ECU assignment"
.
TROUBLESHOOTING
The connected implement is not shown?
The AMAPAD did not recognise the
connected implement.
1. Check the connections.
2. Repeat the process, see page 85.
5.3 Selecting the implement
In this menu, configured implements can be selected. In
addition, implement data can be imported from a USB
stick and copies of the implement data can be made.
1. In the setup menu, tap on
"Implement"
>
"Select"
.
2. Select implement from the list.
001574
F | Configuring the AMAPAD | Configuring an implement
MG5574-
EN
-II | B.1 | 25.10.2016
86
